Let us help you keep your cooling and heating equipment running flawlessly year-round.

Our preventative VAC Maintenance Contract will give you peace of mind that your heating and cooling system is running efficiently. Don’t wait for a breakdown. We provide maintenance such as coolant recharge and inspect HVAC parts that are likely to wear out.

Our Exclusive Precision Tune-Up Procedure Includes, As Needed:

Heating System

Inspect and tighten all electrical connections and terminals
Remove, clean, and adjust main gas burners
Remove clean and adjust ignition/pilot assembly
Thoroughly brush and vacuum clean and heat exchanger(s) and combustion chambers
Inspect heat exchanger(s) & combustion chambers for cracks, rusting, or problem areas.
Inpsect the flue assembly and test flue gas drafting mechanism
Test and inspect all furnace safety controls
Test, record, and adjust gas pressure
Replace or clean standard air filters
Lubricate all fan motors and all moving parts
Measure and adjust blower for correct airflow
Adjust all dampers and set proper blower speed(s)
Measure and adjust blower for correct airflow
Adjust all dampers and set proper blower speed(s)
Measure and record heating system output
Inspect and test thermocouple output as well as pilot safety switch
Measure and record electrical voltage, amperage, and component resistance
Inspect and test all system transformers, relays, contactors, controls, and measure performance
Perform a complete electronic carbon monoxide check of the entire house
Advise customer on other ways to reduce energy consumption, improve safety, and enhance comfort

Benefits:

Lower utility bills
Extended equipment life
Fewer repairs, breakdowns, and improved system reliability
Peace of mind for you and your family
Increased heating capacity
Prior service scheduling

A/C System

Thoroughly clean and replace standard air filter(s)
Lubricate motor and fan bearings as well as other moving parts as necessary
Inspect evaporator coil and drain pan when readily accessible
Clean and inspect condensate drain lines and fittings
Adjust and thoroughly clean blower motor and fan assembly as needed
Inspect, tighten, and test all electrical connections (This includes disconnect switch)
Inspect all cooling system electrical wires, connectors, and terminals
Test system starting and running capacitors
Test all controls, switches, relays, transformers, contactors, motors, and fans
Measure starting and running amperes. lines voltage and control voltage
Test system starting capabilities
Test system for proper airflow and air delivery
Inspect and adjust all safety controls
Monitor refrigerant (Freon) pressures and temperatures
Test and record super-heat and sub-cooling; compare with factory specifications
Test and measure air conditioning system for proper production and capacity
Monitor fan motors and compressor operating temperatures